Modern miter saws are engineered for quick, clean, and precise cuts. However, the quality of the results depends on how well you use its features and other enhancements. It is important to study all the features on the miter saw and follow the manufacturer’s recommendations about their usage.

Before you begin the cutting process, you must ensure that the miter saw is in perfect working order and properly positioned on its surface. Secondly, you should check the work piece for any defects that could damage the miter saw or compromise on the quality of the results.

Hold the Stock firmly against the Fence

Positioning of the stock determines the efficiency of the sawing process and the precision of the cut. Any work piece that you intend to cut must be rested firmly against the fence of the miter saw. This prevents movements of the work piece, which might alter the alignment of the blade to the marked area.

Miter saws are designed with clamps, which are crucial for maintaining a firm hold on the work piece in order to stabilize the sawing process. Once the piece is held in place, the cutting process becomes faster, easier, and more accurate.

Confirm your Angle Settings

Any miter saw will only cut in accordance with the accuracy of the angle settings. Therefore, you must ensure that the bevel and miter angles are accurate before you embark on the cutting task. If you intend to make a crosscut, make sure that both the miter and bevel angles are precisely at the zero mark.

For a compound cut, you should set your miter angle at 31.6 degrees and the bevel angle at 33.9 degrees. You should also ensure that the angles for your miter cuts and bevel cuts are accurate before you engage the miter saw into the cutting process. Always counter-check your angle settings if you want to make perfect cuts with miter saw.

Ensure that the Blade is aligned to the Marked Area

Before you begin the cutting process, make sure that the blade is in line with the marked area. You can do this by lowering it until it touches on the marked surface. Once this process is complete, you only have to start the saw and lower it gently into the stock so that it cuts the work piece completely. It is not necessary to apply excessive force when you are cutting through the stock.

Most miter saws have laser guide systems that make it easier for the operator to establish the precise line of cut. Experts have always recommended using miter saws with laser guides in order to enhance the quality of accuracy.

Do not Lift the Blade before it Stops

Many miter saw operators usually compromise the quality of their work by lifting a spinning blade from the work piece after the cutting process. The habit results in chipping, scarring, and tearing of the work piece, which may render the piece useless for the intended task.

Therefore, you must wait until the blade comes to a complete stop before you lift it up in a gentle manner. Moreover, it is recommended to ensure that the blade is sufficiently tight before engaging it on the cutting task. Following these instructions will enhance the quality and efficiency of your sawing.